Bissell proheat 2x lift off not spraying water on floor

Document

NOTE: There will be no spray to the hose while the Lift-Off Pod is connected to the base

Check for spray at the end of the hose

• Remove Lift-Off pod from base

• Fill clean tank with warm water
• Empty dirty tank
• Secure both tanks into machine

• Unwind hose, give a few light tugs to release kinks in internal water line
• Remove tool if attached
• Turn machine on, squeeze trigger on hose

• If hose sprays, skip down to NO SPRAY TO FLOOR
• If the hose sprays in step above, but doesn’t spray when a tool is attached, then the tool is clogged
  • Clean tool by inserting a paper clip into the spray tip
  • If tool doesn’t clear, it should be replaced

Check clean tank

• Remove clean tank, check the bottom for any deformities
  • The tank should be flat across the bottom edge (no bumps or curves)
  • It should sit flat on end of counter/table without wobbling
  • If it is not flat, it should be replaced as it won’t fit securing into machine (causing no spray)

• Confirm that the red gasket is attached to the end of the cap on the bottom of the tank
  • If missing it should be replaced
  • If found in base of machine, it should be removed and reattached to the bottom of the clean tank

• With water in the clean tank, hold tank (cap side down) over the sink
  • Press upward on the X-valve in the center of the cap
  • If water does not release, the cap & insert should be replaced
  • If water releases from cap, return tank to machine
• Turn machine on & check for spray from the hose
  • If still no spray to hose, visit a BISSELL Authorized Service Center or Contact Us

NO SPRAY TO FLOOR

• Check the trigger on the handle for tension

• If the trigger has tension, uninstall handle – remove 4 screws (arrows)

• Reassemble – align with no visible gaps
  • If no tension in the trigger, the handle should be replaced visit a BISSELL Authorized Service Center or Contact Us

• Clean the solution filter (ON SELECT MODELS)
  • Open the red solution filter cap on the base of the machine by inserting a coin or flathead screwdriver
  • Remove the white filter by lifting by the post
  • Rinse under water to clean
  • Replace the white filter & red cap, turn clockwise to tighten securely

  Clean Spray tips

  • Press on the easy to remove strap tip tabs to lift them out
    • Keep track of which side each tip is removed from, to correctly install back into machine once clean
  
  • Clean each spray tip with an old toothbrush & warm water
  • Spray tip can be soaked in warm water if extremely clogged
  • Return spray tips to machine, they should “click” into place
  • Return Lift-Off pod to base
  • To make sure pod is secured correctly the heated cleaning light should be on once machine is turned on
  
  • Turn machine on, lower handle and pull trigger on handle to check for spray
    • If machine does still not spray to floor, visit a BISSELL Authorized Service Center or Contact Us

Was this answer helpful?