Open Today! 9:00 AM - 7:00 PM
Checking the transmission fluid in your car is a relatively simple procedure and should be done about once per month. To get the most accurate reading you should check the transmission with the engine running and properly warmed up, on a level service.
- First, remove the dipstick from under the hood (if you are unsure as to where it is located, check your owner's manual).
- The handle is usually a bright color (generally yellow or red).
- Remove the stick, wipe it clean, replace, and then remove it again.
- There are labels for "Warm" and "Cold"- check the warm readings.
- If it is not full, slowly fill the fluid up a little at a time, and continue to measure with the dipstick.
- To fill the fluid you should use a funnel and pour it into the hole where you pulled the dipstick. After filling, replace the dipstick, and after a few moments remove to confirm that it has been done correctly.
When checking your transmission fluid be sure to check it's color. Transmission fluid is a pinkish/red color. If your fluid is brown that is a sign that there may be something wrong with the car. If this is the case, schedule an appointment, where our experienced technicians are more than happy to help!
How to Read Dipstick for Transmission
Burning Brakes
Thread Starter
iTrader: (4)
Join Date: Aug 2009
Location: NYC
Age: 32
Posts: 1,004
How to Read Dipstick for Transmission
Hey guys, sorry if I sound like a complete noob but how do you properly read a the dipstick for the transmission? I did a drain and refill yesterday by myself and I'm not sure whether or not I drained 3 quarts or not. When I poured the fluid back into the containers I was only about to fill about 2 1/4 bottles? Keep in mind that a bunch of fluid also missed the pan when I first loosened up the drain bolt.
Here is the dip stick after driving the car for a good hour or so:
I know the fluid is supposed to be between the two hole near the end of the dip stick but after taking the dip stick out, wiping it, putting it back in and taking it out again the areas that are wet is up at least an inch or so.
Last edited by ArthurL; 07-10-2012 at 10:33 AM.
Instructor
Join Date: Nov 2001
Location: Atlanta, GA
Age: 46
Posts: 200
Likes: 0
Received 1 Like on 1 Post
You need to follow the user's manual on how to check fluid level. You shouldn't drive the car and check the fluid level right after (fluid already flow everywhere in the trans case) . Let the car complete cool down and park on level ground first, start the car and turn on the AC so the car reach normal operational temperature faster, wait till the radiator fan kick in for the first time and shut off the engine right away, within 90 seconds check the ATF level.
The following users liked this post:
Team Owner
Join Date: Mar 2006
Location: Bakersfield
Posts: 20,172
Engine off, level ground. It can be a little past the top hole, won't hurt a thing. If it gets too high, you can get aeration and leaks, especially from the axles.
Read the lowest side of the dipstick.
Pro
Join Date: Jan 2009
Posts: 598
Likes: 0
Level ground, warm transmission, engine off. It's best to check it after driving a bit, a few minutes after stopping the engine.
I tend to prefer having the level right on, or very slightly above the upper dot. Mid-Way at the lowest.
Burning Brakes
Thread Starter
iTrader: (4)
Join Date: Aug 2009
Location: NYC
Age: 32
Posts: 1,004
I just checked again.. ran the motor until running temperature.
Hopefully the picture above is clear enough but the fluid level is a little less than half an inch above the top hole (both sides were the same this time around).
Is that okay?
Last edited by ArthurL; 07-10-2012 at 05:03 PM.
Pro
Join Date: Jan 2009
Posts: 598
Likes: 0
Definitely a bit towards the high side, but higher is way better than lower when it comes to AT's.
It's probably 'OK', but I would pump some out the dipstick since its easy. Probably a bit harder if you don't have anything to do that with.
Burning Brakes
Thread Starter
iTrader: (4)
Join Date: Aug 2009
Location: NYC
Age: 32
Posts: 1,004
Quote:
Originally Posted by ZOMGVTEK
Definitely a bit towards the high side, but higher is way better than lower when it comes to AT's.
It's probably 'OK', but I would pump some out the dipstick since its easy. Probably a bit harder if you don't have anything to do that with.
What if I don't have one of those pumps? I'd probably have to let some out through the drain hole right?
Pro
Join Date: Jan 2009
Posts: 598
Likes: 0
Yeah, opening the drain plug really fast would work, but could get messy...
I'm not sure it's worth it. I suppose you could try to just crack it open and keep it in, so just a little drips out?
Team Owner
Join Date: Mar 2006
Location: Bakersfield
Posts: 20,172
It's fine where it is. Mine is always that overfull..... when hot.
~*~
Join Date: Dec 2009
Location: Long Island, NY
Age: 36
Posts: 170
Received 0 Likes on 0 Posts
Complete noob with transmission, even after enduring a ridiculous two year battle with Acura for a rebuilt one after mine had intermittent trans failure.
My car slipped completely out of gear last night (see entire thread here, last post by me)
//acurazine.com/forums/3g-tl-problems-fixes-114/yet-another-serious-transmission-issue-almost-out-warranty-815616/
I checked my ATF fluid with the car cold and it read below both indicator marks. I turned it on and switched through gears for a couple minutes and it read high on the stick a minute after shutting the car off. Which is accurate??
Thread
Thread Starter
Forum
Last Post
mada51589
3G TL Problems & Fixes
79
05-03-2022 09:54 PM
thegipper
3G TL Problems & Fixes
18
10-21-2015 08:19 AM
rklatzkin
3G TL Problems & Fixes
3
09-23-2015 05:08 PM
carz0159
Car Talk
37
09-20-2015 07:11 PM
asahrts
Member Cars for Sale
0
09-04-2015 06:55 PM
02, 2005, 2006, acura, atf, dipstick, dot, honda, level, oil, read, rl, stick, tl, transmission